DAC connections - PCM5102

I just picked up a really cheap PCM5102 based board to see if my pi0 was capable to being my music streamer.
The board in question is:

Old connections:
[spoiler]Connections:
Vcc - pi 5v pin 2
3.3v - pi 3.3v pin 1
GND - pi gnd pin 39
FLT -
DMP -
SCL - pi SCL pin 5
BCK - pi BCK pin 12
DIN - pi Data pin 40
LCK - pi LCK pin 35
FMT -
XMT -[/spoiler]
Software: Volumio 2.001 & output device as Hifiberry Dac

However, no music :frowning:
Anyone have any experience with this board? I am now going to try pulling the FMT and FLT to low as the datasheet recommends.

EDIT: Looked up the data sheet and now it works fine :slight_smile:
Here is the correct pinout:
Vcc -
3.3v - pi 3.3v pin 1
GND - pi gnd pin 39
FLT - pi gnd
DMP - pi gnd
SCL - pi SCL pin 5
BCK - pi BCK pin 12
DIN - pi Data pin 40
LCK - pi LCK pin 35
FMT - pi gnd
XMT - pi 3.3v

I have the same and it work. I can controll the volume over the web page volumio.local. But not with MPD.

Can you controll volume with MPD?