Disabling Ethernet like you just did shouldn’t be a problem perse but if you change anything your network configuration, like change passwords or the name of your wifi, you would need access to Volumio.
You could do this via the serial interface but that would be quite a pain and costs you even more. (the cheap usb/ttl adapters don’t have windows 7+ drivers since there knockoff and Microsoft had an driver update a few years ago). Or connect to a screen and keyboard but wheres the fun in that.
So I would not completely disable it, but set a static address outside of your normally used IP range and make sure you remember it. Saves you some trouble/re-imaging/re-installing.
My only misgivings are if you already have a port and cable then you don’t really need this guide in the first place. But if someone gets Volumio working on the Pi Zero…
I just installed Volumio 1.55 on my raspberry Pi 3 which has wifi. I do not have the Pi connected to via ethernet as I would like to use Wifi.
When I boot up Pi / Volumio it seems ok until the very end of the process. Toward the end of the process, I get a message: Fail start par: service(s) returned failure: transient log.
As this is a first-time project for me. I am wondering if the failed message is related to no wifi being configured or is this type of message indicative of some other issues?
This message, as far as I know, is nothing to worry about … I get it too. I vaguely remember reading somewhere in the forums that it was a legacy result of the boot image.
Does it connect to the WiFi if the ethernet port is plugged in? I’ve ran into a similar situation and eventually decided to strip the eth0 stuff out of interfaces as indicated in this topic.
hey i’m newbie,
i have volumio 2 on raspi pi3 connected to a dac marantz na8005. after many troubles it works good. but remains a problem with wifi. i Follow the steps indicated, but an ifconfig shows always 192.168.211.1 and i need always to Force another IP 192.168.1.xxx.
The substance of this thread is a long time out of date. Don’t alter /etc/network/devices.
192.168.211.1 is the IP address of the volumio hotspot. Connect to this initially, if necessary, but then disable and setup your own wifi network through the Volumio UI
I did this and can see many networks from my neighbours and yet cannot see my own home networks. BTW it works fine on Lan but not on wi-fi!? Any clues?
Firstly some details … what is your device, Volumio version, & wifi adapter? Is the installation a fresh flash or an update of an earlier version? Can you see your home wifi on your phone?
Sorry about that. I have a Netgear r7000 router which broadcasts on 2g and 5g which is visible on all devices. I have set permissions for the Lan but the WiFi just does not show up to log into. I have also set permissions for all new stuff to be able to hook up without passwords (temporarily) and still no go. Weird!!! This on 3 raspberry pi 3 b with usb out or with hifiberry DAC plus gpio card. Also used updated as well as original 2.141, 2.163, 2.175 and 2.185 versions. Hope that is enough - please let me know if not.
Thanks
Keith
Btw also tried hotspot with 192.168.211.1 and I can see the raspberry s but I still can’t find my networks even that way.
Weird one this one as I can now see my router and I have not changed any settings on it. I’m confused but at least seems to now be working. I think it might be something to do with amount of items to discover as per my other thread.